Nov 9, 2018 · I'm attaching an LTspice file that simulates a crystal oscillator with resonant frequency 1MHz, and it works fine. But if I change L1 from 2.5 H to 9.8 mH to simulate a crystal oscillator with …

May 22, 2019 · But how can i simulate those two signals on one same line ? A signal line cannot be at two different voltages at the same time. My circuit designs should be regarded as experimental. …

Dec 23, 2019 · I have been trying to simulate a VCO for a CB radio on LTspice, but cannot get it to run. The ac analysis give me a peak at about 3.5 MHz but cannot get anything from the .trans. It is …

Dec 31, 2022 · Does anybody know how to simulate high frequency signal and circuit in proteus? For several hundreds KHz it works well but when signal are in MHz range the circuit does not work. I …

Jul 28, 2021 · I would like to simulate a small signal RF amplifier on VHF. Can LTSpice simulate RF and if so can anyone point me to a tutorial that shows the proper set-up for LTSpice? Thanks...

Feb 21, 2012 · You can simulate voltage and current of a charging/discharging capacitor using the transient analysis function. Go to Simulate-->Analyses-->Transient Analysis.

Jun 13, 2019 · Hello, I need to simulate a 3 phase star-delta (Yd11) transformer in LTspice. Any idea of how can I proceed? Thanking in anticipation.

May 9, 2017 · Hi everyone, I am using LTSpice IV version 4.231. I have a polynomial fit to a current-voltage characteristic curve and would like to simulate in LTSpice using B sources. The polynomial fit …

Dec 24, 2015 · Hello I make a simple simulation of a dc current source applied on a 10 Kohms thermistor. When I perform a transient simulation (I1 = 10 mA until 10 s) , the thermistor warms up …

Feb 15, 2013 · Hi, I wrote UART code that sends UART data to the PC. I want to simulate it and therefore need to see a terminal that will present the data being sent to the PC from the PIC during …